Naviter Support Forum

Andrej,

( this thread for background: SeeYou fails to see GPS data http://localhost/naviter_forum/discus/forum/messages/1031/1335.html?1106615029 )

   I believe that I have discovered the cause of our problem with the NODATA messages.
I upgraded to Win CE 2003 the 11 of January.
Since that time I have, until today, not been able to connect to the iPAQ3975 com 6 4800 baud.
Here is what the PPC does:
After starting mCU an initial NODATA msg apperars followed by BAD... .
Shortly after mCU locks on to the GPS (com6 4800 n81).
Again after a short time,30-45 seconds, NODATA appears and the cycle repeats untill shutdown.
Now here is the curious part: using a GARMIN etrx GPS on com1 mCU has NO trouble seeing the Com1 and working properly.
This problem apperars to me to be directly related to the upgrade PPC ce 2003 and the Com 6 port.
To eliminate a hardware problem I used my friends EMTAC GPSjac (same as mine) to determine if my iPAQ had a connection  

problem. This test elimininated that possibility.

I am unable to reload PPC CE 2003 or I wouldn't trouble you with this.

I know your team will be able to address the fix as you have many others in the past.

Good luck.
Hope to hear from you soonest.
Rod

Andrej
V2.2

Andrej
Am in receipt of your email instructing me to load V 2.2.  
I have had V 2.2 loaded since the latest build released 27.12.04.
See this thread for a recap of the problem.

iPAQ 3975
PPC v3.0
256k storage card
EMTAC GPSJAQ gps
com 6 baud 4800
Intel PXA250 http://www.intel.com/design/pca/prodbref/298620.htm
ARM* Architecture v.5TE compliant

63.18MB


MS Streets and MAps works  
Cruxview II works (EMTAC gps test program)
mCU terminal mode fails to display any data whatsoever

I have done a hard reset
deleted all directories and reinsatlled mCU v2.2